Dymo S180 User's Guide download pdf (Page 8)

Using the Hold Feature

When an item being weighed extends over the front of the scale and you cannot see the

display, you can freeze the display so that the weight is still displayed after removing the item.

To use the Hold feature

1. Press .

The display shows HOLD and then 0.0 when ready.

2. Place the item on the scale.

3. After a few seconds, remove the item from the scale.

The weight continues to be displayed for about ten seconds.

4. Press

to deactivate the hold feature.

Changing the Units of Measure

Your scale can display weight in English (pounds) or metric (kilograms) units. The default unit

of measure is metric. Each time you turn on the scale, the scale defaults to the unit of measure

that was last used.

To change the units of measure

♦

Press to toggle between English and metric units.

Mounting the Display

The scale features a detachable display. The display can be mounted to most metallic surfaces

using the built-in magnets. You can also mount the display using the mounting holes on the

back of the display and standard screws. A mounting template is included at the back of this

User Guide. The display can be mounted up to 1.8 meters (6 feet) from the scale base.

To mount the display to a non-metallic surface

1. Drill two holes 120 mm (4 3/4 inch) apart at the desired height on the wall using the

template at the back of this User Guide.

2. Screw one screw into each of the holes until the screw head sticks out from the

wall 3 mm (1/8 inch).

Allowing the screw heads to stick out farther than

3 mm (1/8 inch)

may damage the

scale display.

3. Align the holes on the back of the scale display with the screws.

4. Slide the display onto the screws.

The display should slide onto the screws firmly and securely.

HOLD

kg lb

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 133 134

No comments

Dymo S180 User's Guide Page 8