Dymo LabelManager 280 User Manual download pdf (Page 5)

About Your New Label Maker

With the DYMO

LabelManager

280 electronic label

maker, you can create a wide variety of high-quality, self-

adhesive labels. You can choose to print your labels in

several different fonts, text sizes, and text styles. The label

maker uses DYMO D1 label cassettes in widths of

6 mm (1/4”), 9 mm (3/8”), or 12 mm (1/2”). These label

cassettes are available in a wide range of colors.

Visit www.dymo.com for information on obtaining labels

and accessories for your label maker.

Product Registration

Visit www.dymo.com/register to register your label

maker online. During the registration process, you will

need the serial number, which is located inside the back

cover of the label maker.

 An additional one year of warranty

 Notification of software upgrades by email

 Special offers and new product announcements

Getting Started

Follow the steps in this section to print your first label.

Connecting the Power

The label maker is powered by a rechargeable, lithium-ion

(Li-ion) battery pack. To save power, the label maker

automatically turns off after two minutes of inactivity.

Remove the battery pack if the label maker will not

be used for a long period of time.

Inserting the Battery Pack

The battery pack included with your label maker comes

partially charged. For best performance, fully charge the

battery as soon as possible.

Make sure the charging adapter is disconnected

before handling the Li-ion battery pack.

To insert the battery pack

1 Slide the battery compartment cover away from the

label maker. See Figure 2.

2 Insert the battery pack into the battery compartment.

3 Replace the battery compartment cover.

Make sure to read the Li-ion Safety Precautions

found on page 17.

Recharging the Battery Pack

A charging adapter is included with your label maker for

recharging the battery pack. Charging the battery pack will

take approximately three hours; however, after charging

for about 10 minutes, the label maker can be used to print

labels.

The charging adapter is only used for recharging the

battery pack; the charging adapter cannot be used to

power the label maker.

To recharge the battery pack

1 Plug the charging adapter into the power connector

on the top of the label maker.

2 Plug the other end of the charging adapter into a

power outlet. See Figure 3.

Make sure to read the Li-ion Safety Precautions

found on page 17.

Removing the Battery

Remove the battery pack if the label maker will not be

used for a long period of time.

Make sure the charging adapter is disconnected

before handling the Li-ion battery pack.

To remove the battery

1 Unplug the charging adapter.

2 Slide the battery compartment cover away from the

label maker. See Figure 2.

3 Remove the battery from the battery compartment.

Make sure to read the Li-ion Safety Precautions

found on page 17.

Figure 2

Figure 3

1 2 3 4 5 6 7 8 9 10 ... 16 17

Comments to this Manuals

No comments

Dymo LabelManager 280 User Manual Page 5

Comments to this Manuals

Related products and manuals for Printers Dymo LabelManager 280