Dymo Wireless PnP User's Guide download pdf (Page 13)

LabelManager

Wireless PnP

User Guide

Refer to the documentation that came with your router or access point to

determine the connection methods supported.

To configure the label maker on your wireless network

1 Plug one end of the USB cable into the USB port on the back of the label

maker.

2 Plug the other end of the USB cable into an available USB port on your

computer.

3 If necessary, press the power button to turn on the label maker.

4 Start the built-in software.

See Starting the Built-In Software on page 10.

5 Click on the software toolbar.

The Wireless Setup tool starts.

6 Select one of the following connection methods:

• Standard - See Configuring Your Label

Maker Using Standard.

• Advanced - See Configuring Your Label

Maker Using Advanced.

7 Follow the instructions in the tool to configure the

label maker on your wireless network.

The wireless status light located on the top of the

label maker turns solid blue when the label maker

has successfully connected to a wireless network.

You cannot use the label maker as a wireless network printer while the label maker

is connected to a USB port on your computer.

Connection Method Description

Standard Use this method if you want the Wireless Setup tool to

automatically detect your network. Your network will be

detected automatically and you will be prompted to

enter your security information.

See Configuring Your Label Maker Using Standard.

Advanced Use this method if you want to enter all network

information manually. The Wireless Setup tool will not

automatically detect your network.

Use this method only if you are very familiar with your

wireless network, or if the other method is

unsuccessful.

See Configuring Your Label Maker Using Advanced.

Wireless

status light

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 24 25

No comments

Dymo Wireless PnP User's Guide Page 13