Dymo Wireless PnP User's Guide download pdf (Page 7)

LabelManager

Wireless PnP

User Guide

Getting Started

Follow the instructions in this section to set up your label maker.

Connecting the Power

The label maker is powered by a rechargeable, lithium-polymer (LiPo) battery

pack.

For best performance, fully charge the battery pack before using your label maker.

Inserting the Battery Pack

The battery pack included with your

label maker comes partially charged.

For best results, fully charge the

battery pack before using the label

maker for the first time.

Make sure the USB cable is

disconnected before handling the

LiPo battery pack.

To insert the battery pack

1 Press and then pull outward

to open the side cover of the label

maker.

2 Insert the battery pack into the battery compartment as shown in Figure 2.

3 Close the side cover of the label maker.

Make sure to read the LiPo Safety Precautions found on page 24.

Removing the Battery Pack

Remove the battery pack when the label maker will not be used for more than

seven days.

Make sure the USB cable is disconnected before handling the LiPo battery pack.

To remove the battery pack

1 Press and then pull outward to open the side cover of the label maker.

2 Remove the battery pack from the battery compartment.

Make sure to read the LiPo Safety Precautions found on page 24.

Figure 2

Press

and pull

1 2 3 4 5 6 7 8 9 10 11 12 ... 24 25

No comments

Dymo Wireless PnP User's Guide Page 7